![]() ![]() The brackets will also allow you to add the fourth (not bonded) frame side if you need to. You don't want to split the wood or have screw tips poking out the other side. Be careful not to use screws that are too long or too big. Once this is done take the four brackets and use them to reinforce the corners (see pictures). We need to leave the fourth side open as before. I attached all four sides together and then laid the glass down into the wooden frame.īe sure that you stick the tree pieces of frame on the sides that are closed off. How you do this will depend on your own preference or way of doing things. You now have to stick these frame pieces so the corners all line up. Place it on the back side of the frame pieces (see picture). It was more flexible and contoured to the wood better). Now place the foam mounting tape on 3 of the frame pieces (here we used a foam mounting tape from Duck. You will want to size the frame so that the wood overlaps the glass about 3/4 inches on all sides. The frame can be cut many ways, but we just used four pieces cut at 45 degree angles for the corners. Place the other piece of glass on top of the tape and make sure it is aligned with the bottom piece.Ĭut out the four sides of the wooden frame. You may also have your own methods for cleaning glass and not leaving dust behind, but try to stay away from paper towel. Use glass cleaner and a special microfiber cloth. They will not be accessible after you bond them. Once the three sides are taped with the appropriate amount of layers, be sure to clean the inside of both glass pieces. Different thicknesses of hearts will call for different amounts of tape layers. ![]() I then made sure that the space was big enough for one heart to fit through but was small enough that two could not fit at the same time (so they wouldn't overlap). ![]() This provided me with the same space as would be between the two pieces of glass. I had to use 3 layers of tape to get the correct spacing (each layer applied the same as the first).īefore I started I took a couple popsicle sticks, stuck several layers of the tape on each end of a popsicle stick and then stuck the other popsicle stick on top. The idea is to use the tape both as a way to bond the two pieces of glass together and to act as spacers. Where our tape was 1" wide we could use the surplus piece again. It was 1" wide) just place it so that 1/2" is on the glass and the surplus width hangs over the edge. It is taped on three sides to leave one side open to drop in the hearts. You can see the profile in the picture.įirst you will need to tape three sides of one piece of glass (this is where we used the Gorilla clear double sided mounting tape). The framing material we use is a trim found at most building supply stores and it is used at the top of wainscoting or wall paneling. They need to be small and the screws can't be too large to split the wood. The corner brackets are as shown in the picture. To bond the wood to the glass we used a regular foam mounting tape (by duck). The one that is used here to bond the two pieces of glass is a clear mounting tape that is about 1mm thick (gorilla brand). The foam mounting tape can be found at most hardware stores.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |